Viewing 1 reply thread
  • Author
    Posts
    • #1972

      audiofish
      Participant

        Hi,

        I am attempting to setup a connection between two IDC777 modules via Auracast broadcast.

        I can successfully connect the two modules, and audio output is working well. However, I’m struggling to configure the autoconnection mode.

        On the receive module, my attempts to set the AUTOCONN_BCAST results in an “ERROR 0x0013” response.

        For example:
        `
        RESET
        IOT747 Copyright 2022
        AudioAgent IDC777 V3.1.70
        Build: 0400427b
        Bluetooth address 245DFC03B8C8
        Ready
        aptX Lossless: OFF
        PAIR_PENDING
        OPEN 245DFC03B8BC BRX1 2 D 223344
        PENDING
        OPEN_OK 1A BRX1 245DFC03B8BC
        MUSIC 1A PLAY
        OK
        LC3_BROADCAST_NUMBER_BIS 2
        LC3_BROADCAST_STREAM_CONNECT
        SET AUTOCONN_BCAST=245DFC03B8BC AA-03B8BC ON
        ERROR 0x0013
        SET AUTOCONN_BCAST=245DFC03B8BC AA-03B8BC 1
        ERROR 0x0013
        SET AUTOCONN_BCAST=245DFC03B8BC BRX1 ON
        ERROR 0x0013
        SET AUTOCONN_BCAST=245DFC03B8BC ON
        ERROR 0x0013
        SET AUTOCONN_BCAST=245DFC03B8BC
        ERROR 0x0013
        `

        The 0x0013 error indicates that I do not have the parameters set properly, but at least the first attempt appears to line up with the AudioAgent Manual (AAGENT-IDC7x7-V003, page 68).

        I have tried setting this config right after a RESET command and right after an OPEN command, but this showed the same behavior.

        Interestingly, the default config list does not show an AUTOCONN_BCAST configuration value present.

        I spotted the other forum post about the automatic start ofthe TX side of Auracast coming in a new release (https://www.iot747.com/forums/iot747-topic/feature-request-auracast-at-startup/). Could you give some details about when that might be released?

        Thank you

      • #1973

        IOT747 Team
        Keymaster

          Hello,
          The Autoconn feature came after AA3170. You would need to use a draft release of the new upcoming AA32xx firmware. Please file a ticket support at: https://www.iot747.com/support/open.php, stating company name, project and teh team will give you an early release which has the AUTOCONN_BCAST config. It is a Config like any other Config. Thanks.
          IOT747 Support

          • #1974

            audiofish
            Participant

              Thank you, I have raised a ticket.

        Viewing 1 reply thread

        You must be logged in to reply to this topic.