Home › Forums › IDC747 General Questions › IDC777 I2S issue using UTXV › Reply To: IDC777 I2S issue using UTXV

June 5, 2024 at 2:30 pm #1068

IOT747 Team
Keymaster

    Hello,

    I am not sure I understand your set-up. Could you please explain:

    SetUp1: This is an IDC777 Module installed in a prototype (Host). The Host opens an UTXV with an IDC777 in a IDC777-DISKIT (Device). You do not get any I2S out from the IDC777 module in the Host?

    SetUp2: The IDC777-DISKIT is the host (Host). The Host opens a UTVX with an IDC777 module in a prototype. You get I2S out from the IDC777 in the prototype?

    Is that correct? Please send your UART logs on both side.

    Please note that:

    1) You must pair from the side that will be the host and do the OPEN UTXV
    2) To get I2S signal, you need to SET AUDIO=1 1 and also, you need to have AUDIO_DIGITAL configured to be the Master (if you want the board to generate the clock)
    3) Make sure you get the latest firmware version. Do you use AA-Flasher?

    Thanks.

    Ash